The Water Countertop Drink System is becoming increasingly popular and has been for quite some time. This is because the water countertop, once hooked up to your kitchen counter, makes for an excellent unit to use as a water source. There are many benefits of using such a unit, but these will be discussed in this article. So, here are the basics and tips for installing such a unit in your kitchen.
If you are going to use a pelican water countertop drink system, one of the first tips is that you should install such a unit right after you have gotten rid of all the old bottles of water and other liquids from your household. This is to ensure that there is no buildup of solids in your pipes or shower heads that could cause blockage later. Once you have done so, you can then connect the water countertop drink system to your faucet. Once this is done, you will be ready to fill your glass from the tap itself.
One of the most important tips to follow with such a system is to never let any water sit on the countertop for more than a few minutes. This is because water naturally expands when it is allowed to sit, especially if it is kept in a closed cupboard. It will eventually burst, thus leaking all the harmful chemicals out into the air. If water is left sitting on the countertop for longer than five minutes, you risk not only spilling all the water contents, but also the possibility of the entire cabinet overflowing. Thus, it is recommended that you always wipe the area where you intend to place such a countertop drink system immediately after you get rid of all water from it.
After installing your water countertop filter unit, you should fill the basin or container with water. Do not fill the container until you are completely sure that the water level is sufficient for your needs. The ideal level is about one inch below the water line, so measure and set the unit accordingly.
Next, you need to insert the control key, which starts the motor. Make sure that the key is inserted firmly, as it is quite an easy thing to miss if you are not used to operating such devices. After the water countertop drink system is started, it will take at least five minutes before it is fully operational.
If you find that the water pressure in your home is fluctuating and you suspect that it is the reason why the water countertop drink system is not functioning, you should try to lower the water levels. To do this, you should open up the water valve of the storage reservoir, and then lower it down by opening and closing the valve. Make sure that when you lower it down, you do not cause any damage to the motor or the other parts. If you find that the problem is with the pump, you have to replace it. However, you can solve the problem by using water to fill up the container again.